FRS-15 Gen III Adjustable Cheek Weld Kit

Availability: In stock




Developed in partnership with Mission First Tactical, the Adjustable Cheek Weld Kit adapts the Battlelink BACP Adjustable Cheek Piece to the FRS-15 Gen III Rifle Stock.  The Kit mounts over the side plates on the FRS-15 Gen III and is compatible with all four configurations of the Gen III stock, including A2 and Gas Piston set ups.

The FRS-15 Gen III Cheek Weld adjusts in 1/32" increments and provides a range of zero to 1 1/4" rise.  An additional 5/8" can be obtained by installing the cheek weld in the lower hole positions, giving a total of 1 7/8" rise.  The FRS-15 Gen III Check Weld can be mounted in a forward facing or rear facing direction to accommodate rifles with or without a charging handle.

Cheek welds are made of high strength polymer and available in Black, Flat Dark Earth, or OD Green.

Kit Includes:

Adjustable Cheek Weld
Mounting Hardware
Full Color Installation Instructions

Made in USA

This product is intended for lawful purposes only. It is the responsibility of manufacturers, dealers, and end users to fully understand and adhere to Federal, State, and local laws when using this product. Thordsen Customs LLC and its industry partners will not be held liable for any unlawful configuration or other misuse of its products.


Best alternative on the market to achieve featureless!Review by Ash4ducks
I have (4) of these stocks in order to comply with the CA bans (we won't get into that) along with the cheek weld kits. So far this systems seems to be the the best fit ergonomically especially if running optics or dots. This Thordsen system is a much better alternative than the Mag Lock system which by the way I have (4) of them that are useless and are just a piece of junk. Very happy with my Thordsen system and I highly recommend it. (Posted on 3/21/2018)

Write Your Own Review

You're reviewing: FRS-15 Gen III Adjustable Cheek Weld Kit

You may also be interested in the following product(s)